Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Mr-Glass Construction in Stanton, CA | Elmwood Contractors
Mr-Glass enclosure work in Stanton almost never happens in a brand-new bathroom. We provide independent Mr-Glass service across Stanton for frameless showers, semi-frameless sliders, and custom glass panels, and the one thing that sets our work apart here is that we expect non-standard walls. Stanton’s housing stock is mid-century tract construction on tight lots, which means most enclosures we install go into garage conversions, room additions, or existing bathrooms with studs that settled decades ago. Call (866) 253-8554 for a free estimate.
Why Stanton Residents Choose Us for Mr-Glass Service
We’re an independent Mr-Glass service provider, not a manufacturer affiliate or authorized dealer. That independence matters because it means we recommend what actually works for your bathroom, not what a corporate program tells us to push. Nolan Shepherd, Owner at Elmwood Contractors, grew up in Fullerton’s Sunny Hills neighborhood where late-’60s tract homes taught him early which walls were going to be out of plumb. He’s spent two decades since building a reputation for material selection and framing that hold up through Southern California’s heat cycles without callbacks. Our crew is factory-trained on Mr-Glass hardware and we stock the fast-wear parts locally so Stanton homeowners aren’t waiting on a distribution center in another county. See our full Mr-Glass sales & service page for the broader picture.
Styles & brands we work with







Common Mr-Glass Construction Problems We Solve in Stanton
- Frameless door drift and sweep failure. Stanton’s dry Santa Ana wind months pull moisture out of the air and accelerate urethane sweep degradation on Mr-Glass frameless enclosures. The sweep hardens, the door loses tension, and water starts tracking onto the floor at the curb.
- Hinge loosening on settled studs. Those 1950s through 1970s tract homes along Beach Blvd and Katella Ave corridors have framing that’s moved over the decades. A hinge tightened against a wall that’s even slightly out of plumb works loose within months. We re-shim and re-set pivot hardware instead of just cranking down the screw.
- White haze on 3/8″ glass. Hard Orange County water leaves mineral deposits that etch the surface of Mr-Glass panels. Homeowners often think the glass coating failed. It’s usually surface etching, and we can tell the difference before you spend money replacing a panel that just needs the right treatment.
- Water tracking under semi-frameless sliders. Improperly sealed bottom channels let water run under the curb and into the subfloor. In older Stanton bathrooms with original framing, that water damage is already working before you see any tile discoloration.
- Out-of-square retrofit openings. Garage-conversion ADUs and room additions in Stanton routinely produce walls that are not square. A stock Mr-Glass enclosure won’t fit without custom panel cutting or pivot adjustment, and forcing it creates stress points that fail later.
Mr-Glass Service in Stanton: What Local Conditions Mean for Your Equipment
Stanton is roughly 3 square miles with almost no undeveloped land. That is not a throwaway fact, it is the defining reality of construction here. Nearly every shower enclosure we install in Stanton goes into a garage-conversion ADU or a room-addition bathroom carved out of existing square footage. Non-standard wall dimensions and retrofit framing are the norm, not the exception. A developer building a master-planned community in Irvine gets plumb walls from day one. A Stanton homeowner converting a 1964 garage gets walls that were never meant to hold glass, and we plan for that before the first measurement. We recently installed a Mr-Glass in Cypress frameless enclosure in a garage-conversion ADU off Beach Blvd where the new bathroom wall was furred out to meet code and came in 3/4″ out of plumb. Our tech re-shimmed the pivot hinge and cut a custom 1/2″ panel to keep the door swing clean, then sealed the curb with a fresh sweep. No leaks after the first rain test.
Mr-Glass Models & Products We Service in Stanton
We service the full Mr-Glass line: the Frameless Shower Enclosure in standard 3/8″ and 1/2″ tempered glass, the Semi-Frameless Sliding Shower Door, the Neo-Angle Corner Shower Enclosure, and Custom Cut Glass Panels. When the frame profile is still in production, we source genuine Mr-Glass replacement sweeps, hinges, and seals. When it isn’t, we spec equivalent-tolerance aftermarket hardware so you’re not stuck replacing a good glass panel over a discontinued hinge. If the glass is intact and only hardware is worn, we repair. If the glass is chipped at a hinge point or the panel is out of square, full replacement is the honest call. For homeowners in surrounding areas, we also offer Mr-Glass service in Yorba Linda.
See the difference
Before
After
Before
After
Before
AfterMr-Glass Service Pricing in Stanton
Pricing for Mr-Glass work in Stanton depends on panel size, custom cutting, and whether existing framing needs correction. Here are the ranges we quote most often:
| Service | Price Range |
|---|---|
| Frameless Glass Shower Enclosure (Walk-In Shower Installation) | $4,500 – $12,000 |
| Tub-to-Shower Conversion (glass enclosure included) | $3,500 – $10,000 |
| Shower Replacement | $3,000 – $8,500 |
A free estimate includes measurements, a straight answer on whether repair or replacement makes sense, and a written line-item quote before any work starts. Call (866) 253-8554 to schedule yours.
Serving Stanton, CA — Our Local Coverage Area
We’re based in the Stanton area and know this community well, and we also provide Westminster Mr-Glass service. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs – Mr-Glass Construction in Stanton
Yes, but it requires custom fitting. We shim the pivot hinges, cut panels to the actual wall dimensions, and use the right sweep to handle minor out-of-plumb conditions. A stock enclosure forced into a 3/4″ out-of-plumb opening will fail at the hinges. Call (866) 253-8554 and we’ll measure before you buy anything.
It’s almost always hinge hardware that has loosened because the wall behind it is out of plumb, a common issue in Stanton’s 1950s through 1970s tract homes. We re-shim the hinge and reset the pivot so the door holds its swing. Call (866) 253-8554 for a fix that lasts longer than a tightened screw.
It’s usually mineral etching from hard Orange County water, not a manufacturing defect. We can assess whether the surface can be treated or whether the panel needs replacement, and we’ll tell you straight rather than selling you glass you don’t need.
The enclosure itself typically falls under the plumbing fixture scope of the larger remodel permit. If your room addition or ADU already has an open permit, the enclosure is part of that approved work. We coordinate with the building department as part of the job.
Yes, if the glass and frame profile are intact. We stock common Mr-Glass-compatible sweeps and seals locally so most Stanton repairs are one trip, and we carry the same inventory for Mr-Glass in Midway City. If the bottom channel is corroded or the glass is chipped, we’ll tell you that replacement is the better spend. Call (866) 253-8554 for an exact quote.
Service Areas Near Stanton
Our crews work across Stanton service area and the surrounding cities: Fullerton, Anaheim, Placentia, Brea, Buena Park, and La Habra. We also cover Mr-Glass service in Garden Grove for homeowners just south of Stanton.
Book Your Mr-Glass Service in Stanton Today
If your Mr-Glass enclosure is leaking, drifting, or just wasn’t installed right the first time, call (866) 253-8554. We’ll schedule a free estimate, measure your actual wall conditions, and give you a line-item quote. The right material in the right place. Everything else is just catching up to that decision.
Written by Nolan Shepherd, Owner at Elmwood Contractors, a General Contractor in Stanton serving Stanton and North Orange County. His material selections and Mr-Glass service recommendations come from two decades of jobsite experience, not a catalog.